1、输送带在运输和储存中，应当保持清洁，避免阳光直射或雨雪浸淋，防止与酸碱油类有机溶剂等物质接触，并距离发热装置1米以外。

1, conveyor belt in transportation and storage, should be kept clean, avoid direct sunlight or rain and snow leaching, prevent and acid-base, oil, organic solvents and other materials, and 1 meters away from the heating device.

2、贮存时仓库内温度宜保持-18-40度之间，相对湿度宜保持在50-80％之间。

2, storage, warehouse temperature should be maintained between -18-40 degrees, relative humidity should be maintained between 50-80%.

3、储存期间，产品须成卷放置，不得折叠，放置期间应每季度翻动一次。

3, storage period, the product should be placed in rolls, shall not fold, during the period should be shifted once every quarter.

4、不同种类、规格层数的输送带不宜接在一起使用，其接头最好使用胶接法。

4, different types, specifications, layers of conveyor belt should not be used together, and its joint is best to use glue method.

5、输送带的类型、结构、层数应根据使用条件合理选用。

5, the conveyor belt type, structure, number of layers shall be rationally selected according to the conditions of use.

6、输送胶带运行速度不宜大于2.5米/秒，块度大、磨损性大的物料应使用固定力型卸料装置，应尽量采用低速。

6, conveyor belt running speed shall not be greater than 2.5 meters / sec, block size, wear large material should use fixed force type unloading device, should try to use low speed.

7、运输机的传动滚筒直径与输送带布层的关系、传动滚筒、改向滚筒的配套以及对托槽角的要求应根据输送机的设计规定，合理选取。

7, the transmission roller diameter and conveyor belt cloth layer of the relationship, and the drive drum, to the direction of the drum and the bracket angle requirements should be based on the design of the conveyor set reasonable selection.