1. 机头跑偏的调整
1. adjustment of nose deviation
无论任何原因造成的跑偏，均可用本方法。就是把滚筒临近的几组托辊进行调整，即把跑偏方向的几组托辊向前推（皮带运行方向），往哪边跑就向前推哪边。或者后退另一侧也是同样的效果。调整中需要注意，对于每组托辊的调整尽量少些，但调整的个数可以多一些，同时调整中要边看边调，防止过度。
This method can be applied to any deviation caused by any cause. It is to adjust several groups of idler rollers near the drum, that is, to push several groups of idler rollers in the deviation direction forward (belt direction), which side to run forward push which side. Or the other side is the same effect. Attention should be paid to the adjustment of each set of idlers as little as possible, but the number of adjustments can be more, while adjusting to watch while adjusting to prevent excessive.
2. 皮带中部跑偏的调整
2. adjustment of the deviation of the middle part of the belt
皮带中部的跑偏与安装精度、物料重心等有关，但无论任何原因均可以此法调整。即皮带跑向哪边，就把该边的托辊支架往前推（皮带行走方向）。调整中，如前所述，尽量多调整几个，单个调整幅度尽量少点，调整中，要观察皮带向中部的移动量，经过几圈的运行，若皮带运行良好，紧固托辊支架螺栓即可。
The deviation in the middle of the belt is related to the installation accuracy and material center of gravity, but it can be adjusted by this method for any reason. That is, where the belt runs, push the supporting roller support on the side (the direction of the belt). Adjustment, as mentioned before, as much as possible to adjust a few, a single adjustment as little as possible, adjustment, to observe the belt to the middle of the movement, after a few laps of operation, if the belt is running well, fasten the roller bracket bolt can.
3. 机尾皮带跑偏的调整
3. adjustment of tail belt deviation
机尾皮带跑偏的调整最为简单，皮带往哪边跑，就紧固哪边调整螺栓，即对哪边皮带进行涨紧就行了。
Adjustment of the tail belt deviation is the simplest, which side of the belt to run, fasten which side of the adjustment bolt, that is, which side of the belt to tighten.